Swordfish Pro 240a 4-12S ESC waterproof

Swordfish Pro 240a 4-12S ESC waterproof

$315.00 AUD

 Sold Out 

Category: Swordfish ESCs

RCBB is Australia's original and largest HIFEI dealer agency. Where the website shows stock availability orders will be dispatched within 24hrs - We do not take your payment and then order from overseas resulting in 4 week plus delivery times, as happens when buying from backyard operators in it for a 'quick buck'


Hifei Swordfish Pro 240 amp high voltage water cooled esc. This is a high quality ESC designed specifically for racing boat. Programing can be done with your transmitter, optional program card/handheld, optional USB adapter (Requires Windows xp or newer PC) or optional LCD Program Box/Handheld Unit.

Up to 38 NiCad/NiMh cells or 4s to 12s LiPo. This unit is encased in rubber, making it very water resistant.
Microprocessor controlled
Extremely low resistance (0.00075 ohm)
240A continuous (300 Burst)
Up to 38cells NiMH/NiCad or 4 to 12 cell Lithium-polymer
High rate adjustable switching (PWM:8KHz/12KHz/16KHz)
No BEC(battery eliminator circuit)
Programmable low voltage cutoff
Programmable cutoff types(soft cutoff/hard cutoff)
Timing advance programmable (low/standard/high)
Programming by Hifei Program Card or USB Linker
Firmware Upgradeable
Programmable startup type(very soft start/soft start/fast start)
Thermal Protection(100 centigrade)
Runs motor in forward or reverse by swapping any two motor wire connections.
Safe “power on” arming program ensures motor will not accidentally turn on.
Auto shut down when signal is lost or radio interference becomes severe for more than 3 seconds .After radio connection has been reestablished, moving the throttle to the lowest position can restart the motor.
The ESC is disabled when the voltage is over 51v at power-on.
Case Measures: 4.25 (108mm) x 2.25 (57mm) x .90 (23mm)
Weights: 310g

Requires:
Connectors for both the motor and battery supply end. We recommend 8.00mm bullet connectors.

Also requires a rx battery pack or external bec to power your receiver.

USB programer requires Windows XP, Vista or 7(will not work with windows 8)

  • Manufactured by: Swordfish

This product was added to our catalog on Thursday 24 May, 2012.



Your IP Address is: 54.156.37.174